Climate control🔗

If you have climate control connected, you can use the app to:

• check the room temperature and its dynamics;
• set a target temperature for the location;
• select a suitable preset and/or operating mode and enable automation;
• set the fans speed;
• set the position of the dampers in order to direct the air flow in the desired direction.

The options may vary depending on what equipment you have connected to the AWADA platform. For example, some vendors allow you to select only the operating mode, while others allow you to select a preset and adjust the speed of the fans.

Temperature🔗

The average temperature of the entire room is shown at the top of the climate control panel. If you have several thermometers and want to see the temperature in a particular area, go to advanced mode. Clicking on the temperature reading will open a graph of temperature changes.

Below the average temperature on the control panel is the target temperature - the temperature that the climate control system should maintain. To change it, tap and hold it for 2 seconds, and then enter the desired value.

Preset🔗

Preset — is a set of presets that is responsible for the logic of the thermostat as a whole.

Possible preset variants:

• — mode is not set (if the thermostat allows it).
• — automatic mode (selection based on the internal logic of the thermostat).
• — mode of protection against freezing or overheating in case of long absence of people.
• — daytime mode. As a rule — normal mode while people are present.
• — night mode. As a rule — cooler and quieter settings than in day mode.
• — waiting. As a rule — economy mode when people are temporarily absent
• — comfort. As a rule — the most accurate temperature maintenance.
• Timer — timed operation of the thermostat.

To select a preset, press and hold for 2 seconds , then specify a suitable one.

Mode of operation🔗

Possible mode options:

• — mode not set/not set (if the thermostat allows it).
• — automatic mode (selection based on internal thermostat logic).
• — cooling mode.
• — heating mode.
• — drying mode.
• — ventilation mode (only the fan works).

To select the mode, press and hold for 2 seconds and then specify the appropriate one.

Fan speed🔗

To select a speed, press and hold for 2 seconds , then specify the appropriate one.

Direction of air flows🔗

To change the direction of air flow, change the angle of the flaps. Press and hold for 2 seconds , and then indicate the appropriate angle.

Disable climate control🔗

To disable the control, click .